The nozzle was obviously not an oem flashforge product. i kept this in my kit for an extra nozzle. of course today i had a clog in my original.04 nozzle so i installed this on my printer. it was fine as my printer did its calibration. twenty seconds into the print i hear a scraping noise. i stop the print and wait a minute for the nozzle to cool,when i finally can touch the nozzle i notice it is now wiggling and will not snap back into place. i try the nozzle that was clogged and it snapped right into place. i tried this one again and no go. so i put the.06 nozzle that came with my machine and did a print and it was fine. while my .06 was printing i managed to clean out the clog enough in my .04 to get it to load again and do a successful print. all this nozzle did is destroy my print plate. instead of saving a few bucks it did damage. a very bad experience.
